1. Raise the rear driver side tire with a jack stand and remove it.

This is where the gas tank hoses are located and the only area you will need to crawl under your Jeep.

2. Remove the plastic panel in the rear corner

This is held in place by four plastic rivets. Three of them are visible in the picture. I'm sure you can find the fourth on your vehicle. Remove the rivets by securing the outer portion in place while prying the center outward 0.25"-0.5" with a small screwdriver. The rivets will remove as whole pieces.

3. Disconnect the fill vent hose from the tank.

This is done by removing the hose clamp and pulling the hose off the fill vent neck. You may need to pry it, but it’s only held on with a hose clamp.