Install the driveshaft.
)
I had South Bay Driveline of San Jose, California build a CV driveshaft for me. They were very reasonably priced and BY FAR the most helpful shop compared to the several other shops I contacted before them. The total charge was $224.95 and this included UPS ground shipping to Seattle, Washington. The shaft was built and shipped in the typical 24 hour turnaround time that many driveshaft builders live by.
The stock one-piece driveshaft was 16" from U-joint centercap to U-joint centercap. This may be longer than most stock Jeep driveshafts because it had to be lengthened a couple inches after a Chevy 350 conversion. The collapsed length of the CV driveshaft is easily 5" longer than that.
)
Once installed, the resting length of the driveshaft is about 23" and angles up at 17 degrees.
Congratulations! You no longer need to worry about your Jeep vibrating due to your 3"+ suspension lift.
